1979 f250 crew cab short box 4x4 partial restoration

Price: US $10,000.00 Item location: Draper, South Dakota, United States
  • Condition: Used
  • Make: Ford
  • Model: F-250
  • SubModel: Crew cab short box
  • Type: Crew Cab Pickup
  • Trim: Xlt ranger
  • Year: 1979
  • Mileage: 1
  • Color: Blue
  • Engine size: 400
  • Number of cylinders: 8
  • Power options: Air Conditioning, Cruise Control
  • Fuel: Gasoline
  • Transmission: Automatic
  • Drive type: 4WD
  • Interior color: Blue
  • Vehicle Title: Clear
  • Want to buy? Contact seller!

1979 Ford F-250 Crew cab short box

Crew cab ford currently in primer at my body shop in central sd. Cab doors fenders and hood were taken to bare metal patched lower lh doors and one rh door sis body work with sheet metal pulled to 1/16 inch and did body work and glazed over and finished with 400 grit and then applied 3 coats of ppg vibrance dtm primer. Rear doors have one body line by handle that needs to be straighter. Fenders and hood same treatment for body work. Inside cab complete engine harness labeled chassis labeled short box is origional still needs box sides and tail gate rad support good motor ran wen we got it but alt was locked up. Did not drive it. Know the lock outs need gone through. Truck has clean title in hand and was a clean western sd truck. Customer paid $2500 for truck as is when we got it for him, he has had a bill of 13,000 for a year now and is unable to pay due to health issues so we are putting it up for sale to clear his bill. We ran the bill at 65/50/35/hr on three of us but with his 3,000 total down and starting out as low as we are to get it moved you are getting the job for around 40-hr. We will bolt cab and box on and hook up steering. We can finish the project for u as well how u want. We have a good 89 f350 4x4 in inventory for parts or a 93 roller with 5.13s on 37s. Or we can do about anything like a 5.9 swap etc. Check out Henriksen auto body on Facebook. 6056692059. This was the last project we did without $$ down as had done work with this guy fine in past but now we do run a reverse bill if u desire completion

talked over with customer, we are dropping it to 10,000, which translates into us working on it for about 30/hr, he plans to pay us the difference when he is able, so we will work with that on our end, and someone can get a lot of manual labor for next to nothing! We wont be dropping the price any further, as may have to battle on customer overage owed. we will help with load, bolt cab and body on and hook up steering for transport, so it is good enough for a transporter, as will be sold complete, non running, we will have hood on, fenders in cab, box on, tailgate on, bumpers in box.