1967 C10 SWB BAGGED AND CAMMED

1967 Chevrolet C-10

I am moving and forced to sell my project truck. 1967 C10 short bed. True short bed (not sure if fleet side or step side from factory) Truck has cool patina on it with an ugly yellow bed (bed is rough) but it is all new underneath. New front bumper and headlight bezels. Bagged on all 4 corners, rame and suspension have all been blasted and painted (see picture of chassis before body was put back on). New bushings, ew steering, in drop spindles, lug conversion with front disks. Bags are in the stock spring location and the frame is not built up into the bed so you could return it to coil springs if you prefer. New body bushings. New radiator and radiator support. Cammed SBC with turbo 350, barrel intake, nd open long tube headers. new master cylinder. tons of new stuff. this is a project and still needs lots of work but has had a lot done. It runs but doesn't drive yet. It will need a drive shaft and brake lines. Truck has no wiring in it now, ave a brand new American Auto wire wiring harness for it still in the box. Also still in the box is all the air ride components, gal tank, ual chrome VIAIR compressors, nd Air Lift wiring/controls/manifold. New radial T/A tires on all 4 corners. Inside has a bench seat, nd that's about all these trucks came with. no wiring or gauges. Uses original tank behind the seat, he fuel cell under the bed is not included, t goes with my other motor, just still need to take it out. I stole the battery/cables/carburetor from my other car so you can hear the motor run but they are not included with the truck. This would make a super bad ass cruiser and wont take much to get it on the road, am just moving and don't have the room to take it with me. I know I am missing lots of stuff and have more parts included that I didn't list. I know its ugly up top but is all brand new underneath. also have box of misc parts such as the glove box door, okar pedal pads, okar gas pedal and more. Truck was originally a manual truck and still has the clutch pedal in it. I do have the title. I did have a big block chevy with hooker headers in this truck and when I swapped in the sbc I did not change the motor mounts so they will fit a bbc with headers if you want to drop a big block back in you wont have to change mounts

I know I am missing lots so please ask questions. Located in Canyon Tx

below is a link to a youtube video of truck
https://youtu.be/m-_AGXCylV0

On Jul-06-15 at 17:58:31 PDT, eller added the following information:

Please, f you have less than 10 positive feed back you must contact me before you bid so that I know you are real. If not I will remove your bid. Im sorry to do this, ut I have had to many non paying bidders that all had less than 10 or no feed back. Truck is also for sale locally and I reserve the right to end auction early if the reserve has no been met. Thank you

• Condition: Used
• Make: Chevrolet
• Model: C-10
• Trim: C10
• Year: 1967
• Mileage: 0
• Engine size: V8
• Number of cylinders: 8
• Fuel: Gasoline
• Transmission: Automatic
• Drive type: REAR
Want to buy? Contact seller!