-Widebody-Garrett GT35r turbo-Radium fuel cell-Haltech-Coilovers-Wheels

1993 Mazda RX-7 FD3S

1993 Mazda Rx7 FD LHD

VIN: JM1FD3315P0208924

Est mileage: 95k

Rebuilt title

5spd manual

I have owned this car for 5 years, I purchased the car to build into a competition drift car. Runs and drives on the base map from Haltech but is very rich and needs a solid tune. Starts right up hot or cold and holds a solid idle. The engine was built before my ownership and looks very clean, sounds good and has obvious port work done.

The odometer is no longer working however I have the Carfax that shows a last known mileage of 94,851 a few months before the car was wrecked. I have not added mileage to the vehicle in my ownership so I would assume the car has around 95,000 miles.

The body of the car is decent, no real rust issues but there are dents / dings and the wide body kit needs some work to fit perfectly. Rare bodykit made by Aerokit in the UK, they designed the kit for James Deanes Rx7 FD competition drift car. The very aggressive kit was needed to clear the Wisefab suspension that was going to be used on the car. I did NOT cut the quarter panels out yet, that was going to be done with bodywork and paint so if the buyer wants to take the car back to a stock form that is easily accomplished with minimal work.

The interior is in good overall shape however there are some missing plastic trim pieces here and there but looks good. There are currently no seatbelts in the car as I had a roll cage and harnesses that were going to be used in the build.

· Fluids were just replaced, engine oil, engine coolant, MT90 transmission fluid.

· New NGK Spark plugs.

· Brand new Braille battery.

· The car has an aftermarket viper alarm system.

· There are no speakers in the car.

Drivetrain

· 13b rew 2 rotor ported

· Rats nest removed / intake manifold smoothed and polished

· Haltech Elite 550 ecu

· Haltech terminated wire harness with fuse / relay box

· Mac electronic boost control solenoid

· Relay / fuse added to Haltech box for the fuel cell setup

· Pineapple racing idler pulley kit

· Greddy water pump pulley

· Greddy Alternator pulley

· Greddy Power steering pump pulley

· Banzai Oil pan brace

· LS ignition coils / performance plug wires

· Coolant air separator tank

· Koyo v mount radiator

· V mount intercooler setup with ducting

· Garrett gt3582r BB turbo

· Greddy turbo manifold

· Tial Wastegate (recirculated)

· Downpipe heat wrapped

· Tial BOV

· AN lines for coolant and oil to / from turbo

· Greddy intake elbow

· Dual Large 30 row oil coolers

· Stainless -10 AN oil cooler lines

· Derale oil cooler thermostat

· Banzai diff brace

· HKS hi power exhaust

Fuel System

· Radium fuel cell with weld in cage

· Radium FCST with 3 Walbro 450LPH e85 compatible pumps (1 lift and 2 surge tank pumps)

· Radium 10 micron stainless fuel filter with Radium heat exchanger mount

· Radium billet filler cap

· Radium fuel level sender unit (not installed)

· -8 AN fuel feed line

· -6 AN return line

· -6 AN vent line

· Radium fuel injector bushings

· Full Function Eng Billet Fuel rails

· Injector Dynamics 1050x primary injectors

· Injector Dynamics 2000cc secondary injectors

· Fuel lab fuel pressure regulator with gauge

· -8 AN lines with high flow fittings ran between rails and regulator

Suspension / Wheels

· Megan Racing coil overs

· Front calipers powder coated Red

· Front rotors drilled / slotted

· Cosmis Racing Xt206r wheels 18x9.5 +10 front and rear

· Nitto NT01 245/45/18 rear tires

· Large wheels spacers are used for the rear to match the widebody

Exterior

· AeroKit James Deane wide body kit (front splitter / canards also included not installed)

· Shine auto carbon reinforced lip spoiler

· Vented FRP hood

· Sleek headlight kit with led lights

· 99 spec tail lights

· Hood strut kit

Interior

· Black interior mostly complete in decent shape overall

· Braille Battery with power kill switch located in RH rear bin

· Bride Low max style red seats with Planted bolt in seat brackets (Seats are new but dirty from storage)

· LRB aluminum door panels

· LRB black powder coated dash vent panel

· Center dash gauge pod

· AEM UEGO wideband

· Gauge on steering column (rough shape)

· Circuit quick release steering hub

· Sparco steering wheel

· Autoexe carbon fiber shift knob

· B&M short shifter

· Double din radio

• Make: Mazda
• Model: RX-7
• Type: Coupe
• Trim: FD3S
• Doors: 2
• Year: 1993
• Mileage: 95000
• VIN: JM1FD3315P0208924
• Color: Black
• Engine size: 1.3L Gas
• Number of cylinders: 2
• Fuel: gasoline
• Transmission: Manual
• Drive type: RWD
• Interior color: Black
• Drive side: Left-Hand Drive
• Vehicle Title: Salvage
Want to buy? Contact seller!