1993 Mazda RX-7 FD - widebody - single turbo - fuel cell - highly modified

1993 Mazda RX-7

1993 Mazda Rx7 FD LHD

VIN: JM1FD3315P0208924

Est mileage: 95k

Rebuilt title

6spd manual

I have owned this car for 5 years, I purchased the car to build into a competition drift car. Runs and drives on the base map from Haltech but is very rich and needs a solid tune. Starts right up hot or cold and holds a solid idle. The engine was built before my ownership and looks very clean, sounds good and has obvious port work done.

The odometer is no longer working however I have the Carfax that shows a last known mileage of 94,851 a few months before the car was wrecked. I have not added mileage to the vehicle in my ownership so I would assume the car has around 95,000 miles.

The body of the car is decent, no real rust issues but there are dents / dings and the wide body kit needs some work to fit perfectly. Fairly Rare bodykit made by Aerokit in the UK, they designed the kit for James Deanes Rx7 FD competition drift car. The very aggressive kit was needed to clear the Wisefab suspension that was going to be used on the car. I did NOT cut the quarter panels out yet, that was going to be done with bodywork and paint so if the buyer wants to take the car back to a stock form that is easily accomplished with minimal work.

The interior is in good overall shape however there are some missing plastic trim pieces here and there but looks good as it is. There are currently no seatbelts in the car as I had a roll cage and harnesses that were going to be used in the build.

Fluids were just replaced, engine oil, engine coolant, MT90 transmission fluid.

Brand new Braille battery. The car has an aftermarket viper alarm system. There are no speakers in the car.

Drivetrain

13b rew 2 rotor ported

Rats nest removed / intake manifold smoothed and polished

Haltech Elite 550 ecu

Haltech terminated wire harness with fuse / relay box

Mac electronic boost control solenoid

Relay / fuse added to Haltech box for the fuel cell setup

Pineapple racing idler pulley kit

Greddy water pump pulley

Greddy Alternator pulley

Greddy Power steering pump pulley

Banzai Oil pan brace

LS ignition coils / performance plug wires

Coolant air separator tank

Koyo v mount radiator

V mount intercooler setup with ducting

Garrett gt3582r BB turbo

Greddy turbo manifold

Tial Wastegate (recirculated)

Downpipe heat wrapped

Tial BOV

AN lines for coolant and oil to / from turbo

Greddy intake elbow

Dual Large 30 row oil coolers

Stainless -10 AN oil cooler lines

Derale oil cooler thermostat

Banzai diff brace

HKS hi power exhaust

Fuel System

Radium fuel cell with weld in cage

Radium FCST with 3 Walbro 450LPH e85 compatible pumps (1 lift and 2 surge tank pumps)

Radium 10 micron stainless fuel filter with Radium heat exchanger mount

Radium billet filler cap

Radium fuel level sender unit (not installed)

-8 AN fuel feed line

-6 AN return line

-6 AN vent line

Radium fuel injector bushings

Full Function Eng Billet Fuel rails

Injector Dynamics 1050x primary injectors

Injector Dynamics 2000cc secondary injectors

Fuel lab fuel pressure regulator with gauge

-8 AN lines with high flow fittings ran between rails and regulator

Suspension / Wheels

Megan Racing coil overs

Front calipers powder coated Red

Front rotors drilled / slotted

Cosmis Racing Xt206r wheels 18x9.5 +10 front and rear

Nitto NT01 245/45/18 rear tires

Large wheels spacers are used for the rear to match the widebody

Exterior

AeroKit James Deane wide body kit (front splitter / canards also included not installed)

Shine auto carbon reinforced lip spoiler

Vented FRP hood

Sleek headlight kit with led lights

99 spec tail lights

Hood strut kit

Interior

Black interior mostly complete in decent shape overall

Braille Battery with power kill switch located in RH rear bin

Bride Low max style red seats with Planted bolt in seat brackets (Seats are new but dirty from storage)

LRB aluminum door panels

LRB black powder coated dash vent panel

Center dash gauge pod

AEM UEGO wideband

Gauge on steering column (rough shape)

Circuit quick release steering hub

Sparco steering wheel

Autoexe carbon fiber shift knob

B&M short shifter

Double din radio

• Make: Mazda
• Model: RX-7
• Type: Coupe
• Year: 1993
• Mileage: 95000
• VIN: JM1FD3315P0208924
• Color: Black
• Engine size: 1.3L Gas
• Number of cylinders: 2
• Fuel: Gasoline
• Transmission: Manual
• Drive type: RWD
• Interior color: Black
• Drive side: Left-hand drive
• Vehicle Title: Rebuilt, Rebuildable & Reconstructed
Want to buy? Contact seller!