1929 Model A ford tudor street rod hot rod project

1929 Ford Model A tudor

This sedan was taken apart 50 years ago, sand blasted and rattle can primered. It does not have any rust holes, will not need patch panels. There is a ripple behind the drivers door that needs to be hammered flat. All the wood is gone. I have all the garnish mouldings and window cranks, and an open California title. The front fenders are rough, there is 3 I was going to weld two halves to make one. The rear fenders are usable but have cracks. The doors are excellent. It's sitting on its original frame and I started rounding parts up for a hot rod chassis, only one frame goes with the car your choice, but the chassis parts go with either frame if you want.The hot rod frame parts include a 4" dropped 46" wide axle with a new reversed eye spring and new spindles. For the rear I have 4 parallel 4 bars and two home made 4 bar rear brackets that were cut off and a bead of weld ran on them that needs to be ground and fitted to the new axle. There is a high mileage 302 ford engine and c 4 transmission that I pulled from a 1981 van that I drove home. This car is disassembled as you can see in the pics so shipping won't work you'll have to pick it up, I'll help load. I'm in Lake Havasu City Arizona 86404. I can store this for a couple of months if you pay the $500 up front or tell me what you need.

• Condition: Used
• Make: Ford
• Model: Model A
• Type: sedan
• Trim: tudor
• Year: 1929
• Mileage: 99,999
• VIN: A3424279
• Color: grey primer
• Engine size: 302 ford
• Number of cylinders: 8
• Fuel: Gasoline
• Transmission: Automatic
• Drive type: RWD
• Interior color: Gray
• Vehicle Title: Clear
Want to buy? Contact seller!