1973 DODGE CHARGER 440 / 5sp MANUAL: HEAVILY MODIFIED

Price: -
Description:

1973 Dodge Charger

EXCELLENT PROJECT CAR!

NOTES:
** ENGINE RUNS ON 7 CYLINDERS. #3 Cylinder down due to valvetrain issue**
**Factory dash and driver's seat has been removed, but are included with sale**
**Supporting paperwork and receipts for most modifications will be included**

ENGINE:
- 440ci: First Run/Sixth Casting of original 6-pack blocks (made for only 2 1/2 yrs)
- Compression ratio reduced from 10.14:1 to 9.96:1 (Full engine specs below)
- All reciprocating parts have been Calico-coated
- All components MagnaFluxed twice
- Fully balanced including dampener, flywheel and cam. Ported and polished intake and exhaust. Cast Iron Heads milled w/ hardened valve seats.
- Doug Thorley Headers
- Milodon 8qt #31580 Road Racing Oil Pan w/ Pickup# MIL-18328

COOLING / FUEL / EXHAUST / IGNITION
- Edelbrock High Rise Intake and 4 bbl Carb
- Griffin aluminum racing quality radiator and overflow
- MSD Primary and Secondary ignition with heat-shielded plug wires
- 3” Jet Hot Exhaust from Collectors to tailpipe
- Flowmaster Mufflers
- Will perform well on 93 Octane fuel; for full performance, use 108 Octane racing fuel.

TRANSMISSION AND DRIVELINE (Keisler Engineering)
- Keisler 5 speed Aluminum Race transmission (#TRM-E4617A rated at 650HP / 650ft lb)
- Billet Aluminum Flywheel
- DSM Custom Driveshaft. 1200 ft lb rated with premium U-joints and slip yoke. Balance Certified
- Stage-3 racing clutch (SDK043) and hydraulics kit
- Tremec Shifter w/ Hurst T Handle (TKO-600)
- Dana 9 ¾ rear end with final drive ratio of 3.55:1

CHASSIS / SUSPENSION / STEERING
- Energy Suspension Polyurethane bushings including Upper/Lower Control arms, Front/Rear Sway Bars, Front Stabilizer rods and Body Mounts
- Energy Suspension Tie Rod Ends
- FirmFeel Steering Gear (https://firmfeel.com)

TIRES / WHEELS / BRAKES
- Mickey Thompson Sportsman S/T Tires (28 x 10)
- American Racing 15” Wheels

INTERIOR / INSTRUMENTATION / BODY
- Autometer Racing Tach, Shift Light, and Oil Pressure Gauge
- Sparco Racing Drivers Seat, Regular front Bucket passenger
- Interior of car has been stripped to bare sheet metal
- Fire Extinguisher mounted behind center console
- Primer Gray exterior
- Body sheet metal is in overall decent condition and will require only minor bodywork to prep it for a good paint job