1955 Chevrolet Bel Air Convertible Project
1955 Chevrolet Bel Air/150/210
1955 Chevrolet Bel Air Convertible Project. Pre assembled to check fit before painting. Body is completely block sanded straight, re primed and ready for final sand and paint. Has been stripped to bare metal, primed with epoxy and finished with all PPG 2K primers. All door, hood & trunk gaps have been set to close tolerances. The original rust free fenders, doors hood, trunkR rocker panel & R quarter panel were retained. This was a very solid and clean car to begin with.
New sheet metal replaced as follows, L full quarter, rear tail pan, inner trunk pan, L floor pan, R partial floor pan, L inner and outer rocker panels, L front and rear floor brace & R rear wheel well.
Body mods, Shaved hood and paint divider moldings. New parts, Smoothie front bumper, Park lamp assemblies, Tail lamp bezels, Headlamp bezels, Black vinyl convertible top, Gas tank & sending unit. Have NOS and restored moldings & all parts vital to a convertible, including glass, all interior trim, front and rear seats, door hardware & solid sandblasted and painted frame. Original 265 engine and stick trans. Too many parts to list. This car is professionally done by my restoration shop. I am retiring at the end of this year and just running out of time. Can finish to any stage if wanted. Feel free to call with any questions. 952 435 7596
- Make: Chevrolet
- Model: Bel Air/150/210
- Year: 1955
- Mileage: 0
- VIN: VC55J103205
- Engine size: 0
- Vehicle Title: Clear Want to buy? Contact seller!