built 350, fast and 100% ready drive

1967 Chevrolet C-10 C10

-for more pictures, clickhere
This truck is solid, fast, complete, and ready to roll. The most remarkable thing about this pickup is the lack of rust. Very solid in the wheel wells, rockers, door frames, under the doors, floors, frame, etc. The bed has rust holes but I wouldn't hesitateto fill it up withheavy stuff. The body panels are not dented, the bumpers shine, the interior is nice. The small window cab looks great.
The built 350 motor starts right up and has that cam burble. It has a good battery, electronic ignition, and power steering. It runs andacelerates smoothly. Brake lines and master cylinder replaced about a year ago.
All lights and signals work.All the gauges work.There is a nice tachometer next to other aftermarket gauges.Dash lights, radio, wipers, ventilation system, heat all work. Cup holders slide out of the dash under the radio, glove box door works properly and has a new box installed. New ignition switch and lock cylinder. Gas tank is clean and doesn't leak orsmell.The tires are wide and in nice shape.The rubber door seals are good and keep the rain out.
Besides the bed, the only non-surface rust on the exterior is at the bottom corner of the doors (shown in the pictures). These are not rust holes. Please see the pictures for the condition ofeverything and ask me ifyou have any particular concerns.
The truck comes with a bed cover. It is an Extang BlackMax. It's been off the truck for a while but I think it will still snap on but the vinyl has gotten abit stiff.
The truck comes with some extra parts. A factory wheel spare (bad tire). I have the grille emblem. The driver vent window gets loose so I am including two vent window assemblies and two new window guide tracksthat guide the big window up and keep it from rattling(they are stiff rubber with fluffy lining). I also have new rubber for the vent window.The driver's window can get off track and need a hand up. I think the included window guide pieces andwindow sweep/feltpieces will probably fix that.
Please look at the extra pictures. Use the link in the first line of this listing. If the link does not work, send me a message and I will give you another way to get to the pictures. I am not a Chevy truck expert so please ask questions. I don't want any disappointments so I am giving a lot of information and lots of pictures. This pickup is not restored and is not perfect. The truck is sold when the auction ends. Any inspection happens before theauction ends.
Motor:350, 4 bolt main
Bored .030 over041 casting heads (Corvette style)
Forged pistons (+7cc)
Bronze valve guides
Screw in studs
Roller tip rockers
Transmission:
Th350TCI clutches and bands
B&M holeshot converter, 9 inch, 2400 stall
Rear end:
3.73 differentialNew universal joints and center support bearing

On Mar-21-17 at 12:22:49 PDT, seller added the following information:

I also will include with the truck a set of four 15" rims that are in the style that is typical of Centerline wheels...they looklike a deep set steel rim with no holes in it. I have pictures with the extra pictures on Photobucket. These are six lug rims in 8" and 6.5" widths. They have tires...the little ones might be ok. The big ones have cool "pie crust" cheater slicks, but one of them doesn't hold air.

• Condition: Used
• Make: Chevrolet
• Model: C-10
• Trim: C10
• Year: 1967
• Mileage: 150,000
• Engine size: 350
• Drive type: RWD
• Vehicle Title: Clear
Want to buy? Contact seller!