1968 Chevrolet C10 Short Bed

1968 Chevrolet Other Pickups

1968 Chevy Short bed truck. New Tremec 5 speed (0 miles and I have the receipt from Hurst conversions). New crossmember and driveshaft. New Centerforce clutch, Centerforce billet flywheel, Centerforce throw out bearing and clutch fork. New Novack clutch slave cylinder. Wilwood discs all around with stainless flex lines. New CCP rear axles with 5 bolt pattern and bearings. New battery. Lowered springs. Wilwood brake (balance bar type) and clutch pedals. Wilwood brake and clutch master cylinders. New CPP drop 5 lug spindles and bearings. New H/D Monroe shocks. New front hubs and rotors. New gear drive lightweight starter. I have a 3.73 posi unit and new clutches that I haven't installed. All the stake holes in the bed have been filled. I have a front bed section for a wood bed also. Nice interior. This truck needs paint, the brakes bleed, the battery charged and new carpets. I have a lot of money in this truck but I just don't have the time to work on it anymore. Ebay makes you put the mileage in the ad. I put 250K but I have no idea how many miles are on the truck. I would want a $500 deposit through Paypal with the rest in cash when you take delivery. You are welcome to come by and look at the truck just call me first - 3 two one 7 five nine 48 nine 1. The truck is located in Merritt Island, Fl
The engine was gone over about a year before I bought the truck. Its a 1970 350 block. I drove if for a few days then parked it and started on the drivetrain and brakes. Here are the specs on the engine:

ACID DIP BLOCK, HEADS, AND ACCESSORIES

BORE AND HONE BLOCK .030 (.0025 CLEARANCE)

POLISH CRANK SHAFT – STANDARD RODS AND MAINS

COMPETITION VALVE JOB

RESIZE VALVE GUIDES

RESURFACE HEADS

PORT AND POLISH INTAKE AND EXHAUST PORTS (STREET)

PORT MATCH INTAKE PORTS AND INTAKE MANIFOLD

CHECK AND RESIZE CONNECTING RODS

INSTALL CAM BEARINGS

R&R PISTONS ON RODS

BALANCE THE ROTATING ASSEMBLY

.030 CAST PISTONS (9:1 RATIO)

MOLY RING SET

.002 CLEARANCE ROD BEARINGS

MELLING MTC CAM SHAFT

SPECS DURATION @.050 – INT. 204 / EXH. 214

VALVE LIFT – INT. 422 / EXH. .444

Z28 HIGH PERFORMANCE VALVE SPRINGS

MELLING HIGH VOLUME OIL PUMP

HIGH PERFORMANCE OIL PUMP DRIVE SHAFT

BRASS FREEZE PLUGS

FELPRO GASKETS

EDELBROCK PERFORMANCE INTAKE WITH HOLLEY CARB

EDLEBROCK VALVE COVERS, BREATHERS, AND AIR CLEANER (MATCHED SET)

ALL NEW HOSES, WIRING, PLUGS, PLUG WIRES

NEW ALTERNATOR / NEW DISTRIBUTOR

HIGH PERFORMANCE CROSS FLOW ALUMINUM RACING RADIATOR

NEW HEATER HOSES, LINES, BOX

• Condition: Used
• Make: Chevrolet
• Model: Other Pickups
• Type: short bed
• Year: 1968
• Mileage: 250,000
• Color: Orange
• Engine size: 350
• Number of cylinders: 8
• Transmission: Manual
• Interior color: Black
• Vehicle Title: Clear
Want to buy? Contact seller!