1947 Studebaker M5 . Truck sat in Montana for years. It has a Chevrolet 283 and a 3 speed transmission with overdrive. This was a stalled project so there is no wirin, fuel lines etc.The engine and transmission were installed well and the fabrication for the tranny crossmember and motor mounts are done very well.I would think any chevy small block would fit on these motor mounts as well? The driveshaft is not in the truck. Body is dented but theres no rust.Nose is loosely bolted to the frame but seems like it will bolt up with good gaps etc I purchased good straight grills and a good fender . All go with the truck.Windows need to be replaced but are available online as a complete set.The truck is a project but a good bit of work has been done. Selling for less than I have into it.