1978 Porsche 911 SC Targa 2-Door hot rod 3.4 project

1978 Porsche 911

1978 targa, I bought this car almost 2 years ago with a bad engine. I tore it down and found 2 spun bearings and one broken ring. Time to rebuild. So i sent it off to a local shop Long story short the shop had the engine for over year. He was supposed to install the intake and have the car running. I just got tired of all the excuses so i brought it back home What it needs to get running? Install oil lines, oil return tubes Wire temp sensors Install intake and plumb fuel install wires and cap Time Engine specs 3.2 case, 98mm mahle pistons making it a 3.4 stock crank 89 cams carillo rods I had planned to do the finishing touches and fire it up, 2 weeks ago i broke my hand in a moto accident and had to have extensive surgery so the 911 would sit for a long while. Im over it at this point haha It has a very clean tub with no rust. While getting it the motor rebuilt i did the following -17 rota fox staggered wheels -added duck tail with metal grille -momo piloto wheel -new winsheild -h4 lamps I dont need to sell it so not giving it away. listed locally on CL too, looking to get into a tundra, m coupe, or water cooled 911

• Condition: Used
• Make: Porsche
• Model: 911
• Type: Targa
• Trim: SC Targa 2-Door
• Year: 1978
• Mileage: 150,000
• VIN: 9118211269
• Engine size: 3.0L 2999CC H6 GAS SOHC Naturally Aspirated
• Number of cylinders: 6
• Fuel: Gasoline
• Drive type: RWD
• Vehicle Title: Clear
Want to buy? Contact seller!