1923 Chevrolet Hot Rod Rat Rod model A

1923 Ford Model A

Titled as a 1923 Chevrolet Superior, I had trouble entering it on the ebay site is why it is listed the way it is, all fabricated new body, flat cleared body, gloss cleared grill shell, pinstripes by busted knuckle, 2x4 .120 wall frame tubing, 3 link ladder bar rearend set up, fully adjustable QA1 aluminum coil overs, 3.43 posi Trac 8.5 10 bolt with disc brakes, one year only early aluminum housing Muncie 4 speed rebuilt by Midwest Muncie, rebuilt Hurst shifter, 4" aluminum drive shaft, Year One AT350PC1 crate motor with Dyno sheet, made 423hp @ 5500 and 444tq @ 4200 and 400tq from 3200 on. Near 10:1 compression so it runs on 91-93 octane. Edelbrock aluminum heads, roller cam, bored .040 over, performer rpm air gap intake, all specs on year one website, weiand aluminum short water, 750 dual line Holley with anodized black aluminum base and metering plates, Weiand aluminum water pump, mini alternator, mini hi torque starter, HEI distributor with pertronics high output coil, spal electric fan, aluminum radiator, model A grill shell, Model A headlights with halogen H11 composite bulbs and turn signals inside, turn signal and high beam indicator lights in center console, 12 gallon spun aluminum gas tank, New manual Mopar steering box mounted under dash for cowl steering, optima red top battery hidden under dash, Willwood master cylinders and hydraulic clutch, Willwood pedals, New Model A dropped front axle with disc brakes, LED zephyr tail lights are very bright, CP3 brake proportioning valve, 4 wheel disc brakes stops the 2020 pound car on a dime, ran a 12.73 in quarter mile with the pictured bias ply white walls, wired with speedway fused wiring harness, all wires and brake lines fastened orderly to the frame, rearend setup to hook and it does, pulls hard and handles very well, almost a 50/50 front to rear weight ratio with driver, new Firestone rear tires which match the front. Oil and temperature gauges only. Working hi and low halogen headlights and turn signals. Real safety laminated windshield. Car has lap seat belts. Car sits 43" tall to the roof. Fits 5'10" driver best, passenger can be 7'. This is more of a performance build as to a real rat rod. I drive it on the interstate as well as through town. Rides well and handles great. Clear Florida title in hand. I built it when I lived in Florida and have since relocated to Indy. Haggerty insured for $25k at under $300 a year due to short driving season and low yearly mileage. Serious inquiries only, not looking for advice or a pen pal. I do not have to sell but have another project in process. Will sell without motor and or transmission

• Condition: Used
• Make: Ford
• Model: Model A
• Year: 1923
• Mileage: 5,500
• Engine size: 357
• Number of cylinders: 8
• Fuel: Gasoline
• Transmission: Manual
• Vehicle Title: Clear
Want to buy? Contact seller!