1967 mustang project

1967 Ford Mustang Coupe

1967 mustang coupe I got as a project. It's got the signal light hood. Is set up for v8 as you can see the 5 hole wheels front and back. It's an 8" rear end. Good solid car. Driver floor pan replaced. Only other rust is were the trunk drop down pans drain out that little hole. No rust at all over the wheels. The glass is all great. And a small dent in the passenger fender. It needs a steering colum and wheel floor shifter, front bumper and emblem for front grill. I was going to get the billet one. I have a new dash pad ignition and all new locks to put in cuz the old keys are gone. The low mile 1971 351c I rebuilt built was only honed so you could bore it later for another rebuild. It's 2v heads with 4v intake and a .548 lift on the cam. I ran it in my torino for 1000 miles runs great but the intake didn't seal right cuz it leaks oil on the top right side. And the 1971 c4 transmission is just stock and hasn't been touched leaks a little but works good. I got this car to put my extra motor and tranny in and have fun with it but my body says it's time to get old. I still have my first car and I'll trade that in for diapers when I can move anymore. This car does not drive it's a project and has no breaks hooked up at all so make sure your shipper knows that. I have a guy that will haul it anywhere within 1000 miles of Idaho. If u buy it I'll give you his number.

• Condition: Used
• Make: Ford
• Model: Mustang
• Type: Coupe
• Trim: Coupe
• Year: 1967
• Mileage: 0
• VIN: T code
• Color: Red
• Engine size: 351 Cleveland
• Number of cylinders: 8
• Fuel: Gasoline
• Transmission: Automatic
• Drive type: RWD
• Interior color: Black
• Drive side: Left-hand drive
• Vehicle Title: Clear
Want to buy? Contact seller!