1930 MODEL A COUPE ***RARE***

Price: - Item location: Crestview, Florida, United States
Description:

1930 Ford Model A Coupe

1930 Ford Model A Coupe

Fully boxed Model A Frame Z'd 2' in rear stretched in front shortened in rear.

Body is made of a coupe front half and truck back half sheet metal roof.

Channeled over frame to sit flush. Has a 283 with double hump heads RV cam,

Fresh Less than 100 miles since rebuild

Edelbrock performer intake / 600 CFM Carb no choke, but never had trouble starting here in Florida.

All new engine components water pump, fuel pump, belts hoses, fan, pulleys etc.

New Chopped Radiator with Trans cooler built in.

Dual under car exhaust mandrel bent.

Car was purchased from builder in California and shipped to Florida.

Garaged and only driven 20 miles since purchase.

Starts perfectly, battery, smoothest idle ever but throaty sound.

All build receipts and paperwork on-hand convey with vehicle.

Amazing rat-rod/hot-rod.

On Oct-29-17 at 09:10:25 PDT, seller added the following information:

New battery installed last month.

On Oct-29-17 at 09:17:51 PDT, seller added the following information:

Tires have little tread, but the car is so light I never considered replacing them. I only put 20 miles on the car. The original owner/builder put less than 50 miles on it. New rebuild has between 70 and 80 miles on it. Transmission shifts smoothly and solidly always at the right time. The leak is minor, only leaked about 1/4 quart every six months. I never tried to tighten the pan bolts, just kept a towel under it in the garage. I waxed the entire car regularly with Meguiars synthetic wax.
Rebuild included brand new alternator, plug wires, plugs, and distributor.

On Oct-29-17 at 11:56:17 PDT, seller added the following information:

I have the following paperwork in a folder:
-Clean title ready to transfer
-Receipt for 16GA sheet metal for floor
-Receipt for 35 3/4" slider spring from Speedway Motors
-Receipt for two brake rotors
-Receipt for new Advanced Auto Parts Gold battery with 36 month free replacement
-Receipt for Lokar shifter-trans adapter
-Receipt for 1932 Ford Master Cylinder/pedal assembly, Short rear axle brackets, steel jam nuts, 1955-68 small block chevy single groove lower pully, 1955-68 small block chevy groove upper pully, steel four blade racing fan (15"), Speedway drum brake residual valve (10psi, purple), Outer tie rod end (11/18-18 RH), Outer tie rod end (11/18-18 LH), Standard steel heim joint rod ends, (5/8-18 RH Male)
-Receipt for U-joint
-Receipt for Carter M4513 mechanical fuel pump, Doug Thorley Headers Collector Gaskets, Mr. Gasket throttle cable brackets, Proform Aluminum aircleaner assembly, Summit Racing street coils, Trans-dapt performance spin-on oil filter adapter, Wix 51045 engine oil filter
-Receipt for new starter, new starter bolts, new motor mounts
-Receipt for oil adapter (3/4"-16) NIPP
-Receipt for 2 new V-belts
-Receipt for fittings, hose end, and battery cable terminal
-Receipt for brakelines, fittings, and clamps
-Receipt for radiator hose, oil dipstick, alternator bracket, wheel nut
-Receipt for ignition coil
-Receipt for 2.25" 3 bolt collector, performance coil black, throttle cable, air cleaner, mechanical fuel pump
-Receipt for ignition wire set, spark plugs, throttle kit
-Receipt for fuel pump push rod
-Receipt for frame tubing
-Receipt for antifreeze, motor oil, fuel filter, wire conduit, grommet, oil cap, primary wire, resistor
-Receipt for transmission fluid, alternator
-Receipt for bullet thermostat, pcv valve, marker lights
-Receipt for High-performance aluminum 3-row radiator 1932-1939 Ford Low-Boy chopped
-Receipt for Speedway steel driveshaft (IMCA modified racing, 18.5" length), 1310 series Chevy to Chevy U-joint
-Receipt for Lokar Automatic shifter GM TH400 32" Stick Lenth, black aluminum knob
-Receipt for wheel cylinder repair kit
-4 Receipts for welding gas
-6 receipts for other hardware
Open to questions, just message me.

On Oct-30-17 at 06:02:18 PDT, seller added the following information:

TH400 transmission