1967 Camaro Pro-Touring Rolling Project

1967 Chevrolet Camaro

1967 Camaro Rolling Chassis. No motor and no transmission.
Purchased the car 4 years ago with intent to do a wide wheel pro-touring car. Life has gotten in the way and is rather it just not sit.
HAS INDIANA TITLE, GOOD VIN TAG, and COWL TAG
Purchased the car with the following metal replaced and/or new
-Full PS quarter.
-Partial DS quarter.
-Floors
-Seat purches.
-Dash
-Rad support, and latches
-upper front valance
-lower front valance (shaved plate holes)
-Square tube back-half
-Full wheel tubs
-Steel cowl hood
-GM fenders (shave emblem holes)
-GM doors
Car has custom roll cage (for rigidity not cert.) Car has an adjustable 4-link with panhard bar and narrowed 9". Comes with Ridetech air bags for front and rear, Ridetech upper control arms, Ridetech drop spindles, CCP tubular lower controls arms, Red carbon fiber framed bucket seats and brackets, LS swap motor mounts, custom fuel cell. I have an F-body radiator that can do with it, along with some random parts (ie, a pillar trim, some brackets, head light buckets, new grill and headlight trim, etc.)
$1000 non refundable deposit from the winner at the end of the auction. Balance at pick-up.
Also for sale locally an I have the right to end the auction at any time.

• Condition: Used
• Make: Chevrolet
• Model: Camaro
• Year: 1967
• Mileage: 0
• Drive side: Left-hand drive
• Vehicle Title: Clear
Want to buy? Contact seller!