1969 Chevrolet Camaro coupe
This is my 1969 Camaro project. I purchased this car about 12 years ago and had it almost finished about 3 years ago until it got driven into my chain link fence around my building. It was nothing serious but it did mess up the sheet metal on the front of the car. At this point the car needs the front body work finished and painted and a little bit of assembly and a little wiring. I cannot find the time to do it anymore so I am selling it along with a 1967 Barracuda notch back in a separate auction. It has an almost new 383 stroker made from a 350 LT1, Block casting 3970010 4 bolt, double hump heads..it screams. Automatic but I was going to put a 5 speed in it so I have all the pedal assembly and clutch linkage to convert. Interior is new but the headliner needs tightening in the back. Dash is new. Car is rust free! No patch job rust repair anywhere. Has 10 bolt rear, power disk brakes up front.(they have light surface rust on them now but are totally new. New exhaust. I have just about everything needed to finish it up ...trim, front spoiler, dual snorkel cowl induction air cleaner, all chrome, front and rear bumpers are new, new taillight lenses and new headlight buckets and hardware. All glass was replaced with new PPG tinted (no china crap). Very easy project for someone with the time and very, very little money. It does need an ignition box, I had a new MSD for it but used it on another car, everything else is there. I have 4 steel factory Corvette steel wheels (15 x 8) with old tires that will be on it when sold. Call 910.792.6263 / 910.616.7792 with any questions.