1968 chevrolet c10 SWB air ride body dropped patina rat rod bagged

1968 Chevrolet C-10 bagged body dropped patina'd short bed shop truck

Up for auction is my 1968 chevy C10 short bed shop truck that underwent a full frame off build. It’s on air ride with a 3”z and motor has been lowered back down 2.25”. It utilizes all its factory trailing arms, control arms, spindles, front and rear frame rails, cross member, that have all been highly modified. All work was professionally done and the work looks great. This has been my personal truck for the last year that I have taken to all the local shows, and it brings attention! The truck runs, rides, and drives great. It’s probably the smoothest riding bagged vehicle I’ve ever ridden in, and can be cruised just inches off the ground. 350/350 Motor and trans supposedly rebuilt and run and shift as they should. Motor has edlebrock intake, mild cam, mild port and polish work on heads, roller rockers, and it starts right up every time and is very fast revving for a 350. It also has brand new edelbrock carb, water pump, starter, fuel pump, exhaust, sending units, and all factory dummy lights work with a backup set of gauges in glove box. New brakes all around, new ball joints, etc. New carpet, kick carpet, dash pad, door weather stripping etc. All paint and body was left alone (other than wet sand and buff) to preserve patina. It does have some rust in the typical spots that these trucks do. Every bit of rust in floor pans was cut out, new panels welded in, ground smooth, seam sealed, under coated, and sound deadener applied. Small trans tunnel was built using factory tunnel, just raised 2” and covered with factory high hump carpet. New tires on freshly powder coated original wheels and original hub caps to this truck. All lights/blinkers, horn, wipers, speedo, etc work. Fuel gauge is hit and miss, and speedo is off at higher speeds. All air ride components are new. 2600# air lift dominators all around, 8 electric smc valves (front, back, side to side), viair compressor, stinger 100 amp relay, etc, it’s all new. Frame vin/vin tag/spid/title all match as a true short bed truck! Bid with confidence because this truck is built right, ready to enjoy, and is a blast to cruise in!!!

PLEASE TEXT OR CALL WITH QUESTIONS 972 571 5822

Truck is sold as is where is with no warranty expressed or implied. Shipping is buyer’s responsibility. Truck is located in Shreveport Louisiana, and Louisiana residents must pay sales tax. $500 deposit due within 24 hours of auction end, and full amount shall be paid in cash or bank wire within 7 days of auction end. IF THESE TIME CONSTRAINTS ARE NOT MET, I KEEP ANY PREVIOUSLY APPLIED AMOUNTS AND WILL RELIST TRUCK.

• Condition: Used
• Make: Chevrolet
• Model: C-10
• SubModel: bagged body dropped patina'd short bed shop truck
• Trim: c-10
• Year: 1968
• Mileage: 1
• VIN: cs148s138051
• Color: Blue
• Engine size: 350 v8
• Number of cylinders: 8
• Fuel: Gasoline
• Transmission: Automatic
• Drive type: RWD
• Interior color: Blue
• Vehicle Title: Clear
Want to buy? Contact seller!