*SEMA BUILD* Turbo Widebody E30

1987 BMW 3-Series

I am looking to test the waters for any interest in my 1987 widebody turbo E30 325i sedan. I had plans on finishing the body work/paint and some TLC such as clean up and a tune. I purchased the car from the builder, Ary at ESM wheels/DTM fiberwerks in LA. It was their SEMA build for 2013 promoting the custom widebody. It's estimated around 300-350rwhp on a very basic low boost safe tune. All the aftermarket parts are new with very little use. The hood and trunk are Boston green while the rest of the car is Alpine white. It was originally wrapped green for the SEMA show. Fiberglass damage over rear wheel wells is due to a previous setup where wheels would make contact over bumps. It runs absolutely great and has never seen the track. Compression test was done at the time of the basic tune with all strong matching numbers. I no longer have the time to finish the car since we have our 3rd baby on the way.
Engine: M20B27 (built by JMP Autowerks) ~500mi
-refreshed bottom end (new piston rings, bearings, ARP rod bolts, decked/honed block)
-MLS head gasket
-ARP head studs
-Resurfaced head
-New valve seals and guides
Turbo/fuel:
-GT35 turbo
-Custom tubular T4 manifold
-3" turboback exhaust
-Custom Plenum intake manifold
-25"x12"x3" large FMIC
-50mm Turbosmart BOV
-50mm TIAL wastegate
-New OEM fuel pump
-Bosch 440cc injectors
-New OEM fuel filter
-Megasquirt 2 software
-Aluminum radiator w/24" slim fan
Drivetrain:
-OEM refreshed tranny
-Short throw shifter
-ClutchMasters stage 3 clutch
-Resurfaced flywheel
-3.73 LSD
-New OEM flex disc
Wheels/suspension/brakes:
-ESM 002R 17X9.5 front 17X11 rear
-Toyo R888 245/40/17 front 275/40/17 rear
-Front/rear spacers
-Front/rear stud conversion
-Ground Control front coilovers
-Spectrum rear struts w/ GC springs
-New OEM front slotted rotors
-New OEM pads (front/rear)
Interior:
-Carbon fiber race dash
-Race Technologies digital cluster (needs programming)
-Innovate AFR guage
-NRG race steering wheel
-NRG quick release hub
-Sparco Pro ADV red racing seat
-Racing harness
-Fully caged and stripped
-Front Condor race poly windows
Exterior:
-Custom DTM Fiberwerks Obsession widebody
-Red quick relaease fasteners
-Rocket Bunny rear spoiler
-Turbo Vented hood
-Carbon Fiber roof
-DTM carbon fiber Vented mirrors
-Carbon fiber front splitter
-Carbon fiber side skirt splitters
-Carbon fiber rear diffuser
-Yellow Hela projecter headlights
-Smoked tailights
-Black grill
Asking $12,000 OBO. I will be open to trades but prefer cash. I can offer to schedule vehicle transport out of state for an additional $1,000. Trades for other built BMW's, LS turbo swaps, 2jz swaps, Porsche's, swapped Datsuns, etc. Thank you!

• Make: BMW
• Model: 3-Series
• Type: Sedan
• Year: 1987
• Mileage: 500
• VIN: wbaae5400h1696326
• Engine size: 2.7
• Number of cylinders: 6
• Fuel: Gasoline
• Transmission: Manual
• Drive type: RWD
• Vehicle Title: Clear
Want to buy? Contact seller!