Toyota Land Cruiser FJ40 1970 Restored
- Condition: Used
- Make: Toyota
- Model: Land Cruiser
- SubModel: FJ40
- Year: 1970
- Mileage: 28,850
- VIN: FJ4093505
- Color: Judson Green
- Engine size: F
- Number of cylinders: 6
- Fuel: Gasoline
- Transmission: Manual column shift
- Drive type: 4WD
- Drive side: Left-hand drive
- Options: 4-Wheel Drive
- Vehicle Title: Clear Want to buy? Contact seller!
1970 Toyota Land Cruiser
Restored Fj40 1970 model for sale. I bought this car from the previous owner who had teared it down for restoration. But he gave up. He had rebuild the motor with "new"crankshaft and bearings, and new seals. The vehicle is imported from California USA in 2011. The emission stuff is missing.
Original strong 3,9l inline six F engine, with three speed columnshift transmission that works well. Vacuum actuated 4wd selector. Locking hubs. Everything works.
Reprinted owners manual and factory service manuals is included.
Mileage is not confirmed as its only 5 numbers
SOLD AS IS with NO warranty.
This is done:
Engine is rebuild with new crankshaft and bearings, new seals. The head is rebuild with new freeze plugs, new improved valve stem seals, replaced rocker assembly with good used one.
Rebuild original carburetor. Ported vacuum port drilled, together with a new OEM non USA distributor. New plugs.
New fuel lines and filter, cleaned and sealed fueltank
New radiator element, thermostat, flushed cooling system.
New custom exhaust
New clutch disk t.o. bearing flywheel bearing... Complete new hydraulic system with new master slave and lines.
Transmission and transfer case is rebuild with new seals some bearings and synchro rings. New output drive flange forward and speedisleeve on seal surface on parking brake drum.
All seals on front axle and knuckles is replaced.
All seals on rear axle replaced
All bearings in the rear differential is replaced
New spring bushings
New dual brake master cylinder, new brake lines, honed and rebuild wheel cylinders, new brake shoes.
New body mounts
All new weatherstripping
Stainless steel nuts and bolts used outside
Some new lights
Tires in original size (Diagonal 7,00x15) New hubcaps
New steering stabilizer, new seals in steeringbox
New upper dashpad
New inner mirror, new sunvisors
New seat upholstery with new foam (only front seats)
Wire harness is unwrapped, bad wires replaced and rewrapped, some new connectors, switches, new fusebox, new ignition switch
The frame is sandblasted and primed with zinkepoxy, then primed with marine primer, then painted. The frame was perfect without rust.
Rusty areas in the tub and door was cut out and replaced with steel.
The body parts is also sandblasted and primed with zinkepoxy, then primed with epoxyprimer, filler and paint. The painting is done by myself and is not perfect.
Message me for additional information