1988 Pontiac Fiero
You are bidding on a 1988 Pontiac Fiero GT (originally a coupe with factory ‘T’ tops). This is a project car that has not been completed. This car and parts are sold as a lot. The buyer is responsible for pick-up and transport of car and all parts at point of purchase. Car and parts are sold as is! The car was purchased by me with a Salvage title but has since been re-titled in Maryland. The car has had no reported accidents. The frame and suspension has been restored, ew bushings, oni shocks, ew door and front trunk/rear trunk weather seal rubber. There is no rust on the chassis of this car. As you can see by the pictures there is a good amount of work yet to be completed, ut I have 99% of the parts and hardware which will be included in the sale. The only major part I do not have is the rear bumper. The engine (not installed) is a 1990 series 1, .8L with a modified wiring harness and ECU for the Fiero. Included are two manual transmissions an Isuzu 5 speed and a Saginaw 4 speed. A new McLeod clutch, ressure plate and flywheel are included. Additional parts included are; Interior wiring harness with fuse box, as fill neck, as lines with sender and pump, xels Left and right, anual shifter with extra cables, slew of misc. sensors, nd misc. hardware – nuts, olts, lips, crews. Three (3) extra dashboards, wo (2) extra center consoles, enter dash trim, hree (3) extra instrument clusters, hree (3) pair extra door panels, hree (3) pair door arm rest/pulls, extra ‘A’ pillar trim, nd Two (2) Delco original part cassette players with EQ. GT sail panels (no cracks), pare wiper motor, ead lights, eadlight buckets, isc belt trim. Fiero Service Manuals, wner manuals. If you have any question regarding the condition of any parts or the car in general please feel free to contact me. My goal is to make sure that there are no surprises. Thank you and good luck with your bidding.