1969 plymouth barracuda 496 c.i. stroker motor project car

Price: US $5,500.00 Item location: Carmichael, California, United States
  • Condition: Used
  • Make: Plymouth
  • Model: Barracuda
  • Type: Coupe
  • Year: 1969
  • Mileage: 48,983
  • VIN: bh23f9b400660
  • Color: Blue
  • Engine size: 340
  • Number of cylinders: 8
  • Fuel: Gasoline
  • Transmission: Automatic
  • Drive type: RWD
  • Interior color: Black
  • Vehicle Title: Rebuilt, Rebuildable & Reconstructed
  • Want to buy? Contact seller!

1969 Plymouth Barracuda

1969 plymouth barracuda
Hello, I am selling a 1969 plymouth barracuda
The car has no title…it hasn’t been registered in 15+ years and is not in the DMV system and will need to have a new title requested by the new owner.
I will provide a bill of sale.
I have approximately %90 of the original parts to this car.
plus lots of aftermarket and replacement parts to accompany this vehicle
When purchased it DID run but no longer has a fuel tank installed so it hasn’t been turned over in about 8 years
this was a project that was started about 9 years ago and was never finished but has a good start.
6 pt cage with side bar swing outs installed
hurst pistol grip three speed automatic shifter and rear wiring harness installed as well
I have all the original seat frames that were redone but the fronts will most likely need to be done again..
the drivers side door is off to be prepped for paint and the passenger door has a 7/10 paint job on it. along with the trunk lid…its a 1998 DODGE VIPER GTS Blue paint color
This was originally a 318 car and now is home to a 340.
I also have a 496ci block with crank and rods and pistons that would be the start of something great.
The 496ci block is on an engine stand and that will be included. It wasn’t wrapped for storage after being machined and will need to be dipped to clean rust but is a 1977 440 block as the base.
The car will also come with a Strange Engineering s60 Rear differential. 35spline axels with a 4.10 gear..the rear end will also need to be blasted and powder coated.
There is no rear axel in the vehicle at the moment and will need a flat bed with a winch to transport.
I have basically everything needed for the car in terms of original parts minus the original 318..
The rear springs have been relocated under the frame rails in the rear to accommodate the largest possible tires in the rear. 10.5" wide.
This car is located in Carmichael,CA
I will not ship this vehicle.
I am open to all offers
please contact me if you have anymore questions