1977 Jeep CJ 5 304 V8 3spd "Project"

1977 Jeep CJ

77 Jeep CJ-5 with a 304 engine with a aluminum edlbrock intake and a holley 600 carb with fenderwell headers and sidepipe exhaust. 3 spd manual trans. It has a full rollbar/cage. The jeep runsif you pour gas in carb. so assuming it needs carb work as it has a new fuel pump. It Just needs some work as most old jeeps do. I dont have the time and the will to work on it. It needs the steering column worked on. The rod that engages the ignition switch is missing. Thejeep does have rust...The floors need replaced and I have all 4 new panels to do so. It will still need the cross brace/seat supportpurchased ($125) to do the job right. The very rear of the frame has rustholes and will need patched but is not unsafe now but rest of frame feels very solid with only surface rust. Its just an old jeep that needs someone that's handy to tinker with it for a bit. It has a new battery/altenator/ignition module/plugs/wires/cap/rotor/solenoid/distributor/Fuel pump. I do have all the seats and comes with a bikini top and a new old stock set of canvas brown half doors but they will need handles. I have driven this jeep but its been over a yr ago. At that time it ran good and stopped steered and shifted as it should. But once again this is a project jeep not something that's going to run and drive without doing some work. IT NEEDS WORK. It will need trailered/hauled to its new owner. Payment will need to be in cash and be required within 7 days of auction closing. Clean clear title in hand.

• Condition: Used
• Make: Jeep
• Model: CJ
• Year: 1977
• Mileage: 99,999,999
• Color: Blue
• Engine size: 304
• Number of cylinders: 8
• Fuel: Gasoline
• Transmission: Manual
• Drive type: 4WD
• Interior color: Brown
• Options: 4-Wheel Drive
• Vehicle Title: Clear
Want to buy? Contact seller!