1966 Mustang Convertible with 351 Windsor

1966 Ford Mustang

Here is a 1966 Mustang Convertible Project roller car that i purchased a while ago,The convertible is a original C-Code car, paint code F which is Arcadia Blue, and Blue w/Blue Trim.
This car is a project that has been on hold for 10 plus years. Included a 351 Windsor motor, and transmission. "not sure what type" The mustang will need a lot of work and i just done have the time for it right now.
New parts installed :
New Floor pans -
New Inner rockers -
New rear quarter panels, but will need some prep work.
(2) New Dynacorn doors with glas, handle, locks all installed
(2) New front fenders
New hood new
New Inner floor rails
New tan roof with very good rear window
Gas Tank.
Seats, Door panels, front and rear seat.
I have tackled a lot of the floor pan welding and inner/outer floor rails but I am limited on time. I have recently patched the firewall on the driver side but still will need work. I have spent many hours in the hot cali sun getting most of the welding done. The passenger side A-Pillar might need to be replaced, i haven't tried to line up that door yet, but just an FYI.
Overall this is a nice start to a project car, most importantly the rear frame rails are solid, The front frame on the driver side rail will need about 6" of the section replaced. The exterior of the car was sandblasted, and is now a tan/yellow primer color. I have began welding a few pieces of the floor pan, and have removed 95% of the surface rush in the inside of the floor pan as shown.I have the California Title in hand. Sold As Is.
Price reduced need gone asap. 1 day only

*Please email prior to bidding if you have less then a 5 feedback rating.

• Condition: Used
• Make: Ford
• Model: Mustang
• Type: Convertible
• Year: 1966
• Mileage: 99,999
• VIN: 6T08C251769
• Engine size: v8
• Number of cylinders: 8
• Fuel: Gasoline
• Drive type: RWD
• Interior color: Tan
• Vehicle Title: Clear
Want to buy? Contact seller!