1989 Shelby CSX-VNT Turbo #14

Price: - Item location: Merrimack, New Hampshire, United States
  • Condition: Used
  • Make: Dodge
  • Model: Shadow
  • SubModel: CSX-VNT
  • Type: Coupe
  • Trim: Shelby
  • Year: 1989
  • Mileage: 129,760
  • VIN: 1B3BP94A9KN645037
  • Color: Red
  • Engine size: 2.2l Turbo IV
  • Number of cylinders: 4
  • Power options: Air Conditioning
  • Fuel: Gasoline
  • Transmission: Manual
  • Drive type: FWD
  • Interior color: Gray
  • Options: CD Player
  • Vehicle Title: Clear
  • Want to buy? Contact seller!

1989 Dodge Shadow Shelby

1989 Shelby CSX-VNT #14
2.2l VNT Turbo IV
Bored over .020
Forged Venoila Pistons
Sealed Power Rings(file fitted)
Crank Micro Polished
All Clevite Bearings
Cryo Treated I-Shaft
Melling Oil Pump(block port matched)
Goodyear Gatorback Timing Belt
Goodyear Gatorback Belts & Pulley
New Seals & Guides
3 Angle Valve Job
New Delta Camshaft
New Adj. Camshaft Gear(set at 0)
New Mopar Performance Head Gasket
New Mopar Performance Head Bolts & Washers
New T25 VNT Turbo
New Mopar Cap, Rotor, Plug Wires
New NGK V Power Plugs
New Walbro 255l Fuel Pump
New Plus 20 Mopar Performance Fuel Injectors
New Accufab Adj. Fuel Pressure Regulator
New EFI Fuel Lines
New Fuel Filter
New Cone Air Filter
New Blow Off Valve
New 4 Wire o2
New Optima Red Top 1000/800CCA
Cooling System:
Reconditioned Radiator(Brass Endtanks)
New Hoses & Clamps
New 180 Drilled Thermostat
Permacool Performance Motor & Fan
All New Hoses & Seals
Reconditioned Compressor
New Clutch
New Condenser
Reconditioned A555
New Spec Stage 3 Clutch
New Throw Out Bearing
New Detroit Axles(Unequal)
New Mobil 1 5W30 High Mileage
New CX Racing Adjustable Front Coilovers
New Monroe Air Shocks
New Polybushings Engine Mounts And Bobble Strut
New Polybushings Sway Bar Bushings
New Drilled & Slotted Rotors
New Pads & Emergency Brake Shoes
New Master Cylinder
New Front SS Braided Brake Lines
New Rear SS Braided Brake Lines(not installed yet)
2.5" MB Exhaust System With High Flow Cat
Wheels & Tires:
New Motegi MR2747 SP10 15x7"/5x100/114.3mm/42mm Offset
New Motegi Center Caps
New Nitto Neo Gen 205/50R15
Tuner Lugs With Key
Stock Fiberides Included(one has small repair does not effect tire seal)
New Carpet
New Headliner
Front seat bolsters have been professionally replaced with all new fabric
Innovate Wideband o2 Gauge
New Door Mirrors
New Headlamps and Bulbs
New Side Marker Lights and Bulbs
New Window Scapers
New Full Decal Kit Included
New Hood Liner
New Wipers
All parts marked New have less than 1000 miles on them. The long block itself has 104 miles on it. Machine work done at Westside Performance(Houston, TX). Engine was seated on a Dyno at FWDPerformance(Tomball,TX). Used 30SAE Non-detergant Oil with CompCams Oil Additive with Zinc. Now has Mobil 1 Full Synthtic 5W30 with Wix Oil Filter.
Car runs fantastic and is very quick. A/C blows cold and Heat blows hot. Everything else works just the way that it should.
Produced 218.4 WHP and 264.1 WTRQ, that's 251.2 HP and 303.7 TRQ at the flywheel on pump 93. I do have the Dyno Graphs. These numbers were verified on 2 different occasions. It's exactly how the car sits right now. Full exhaust, stock intercooler and all belts on. No tricks to inflate the numbers.
Ran the 1/4 at New England Dragway(90ft above sea level) in May. Temp was 63 degrees with 76% humidity. Made 5 runs, pretty much all back to back. Best was a 13.40 @ 99.38 MPH with 24.5 8.0 15 M&H Slicks. A better driver and more time at the track can probably coax even more out. Yes, I have the timeslip for this also.
Car was repainted along with all of the original ground effects and Wing removed(also repainted). It's a 10 footer. It shines up really nice, but there are some runs, minor dings and such.
Ground effects, spare front bumper cover, and brackets will be included. Fiberides, complete KYB Struts, rear shocks, used VNT turbo, and box of misc. parts.
Please look at all pictures closely and carefully. What you see is what you will get. If you need more information or pictures, please contact me. Car is now located in southern New Hampshire. I recently had it shipped up here from our place in MS, hence the plates.