1962 Chevy Impala 2 Door Hardtop

Price: - Item location: Yankton, South Dakota, United States
  • Condition: Used
  • Make: Chevrolet
  • Model: Impala
  • Type: Coupe
  • Year: 1962
  • Mileage: 0
  • VIN: 21847J188358
  • Engine size: 6.0 Liter
  • Number of cylinders: 8
  • Power options: Air Conditioning
  • Fuel: Gasoline
  • Transmission: Automatic
  • Drive type: FWD
  • Drive side: Left-hand drive
  • Vehicle Title: Clear
  • Want to buy? Contact seller!
Description:

1962 Chevrolet Impala

1962 Chevy Impala 2 DR Hardtop. Frame off restoration. All suspension components redone. All new front rubber, tie rod ends, ball joints, etc. Front center link rebuilt, 605 power steering conversion new bracket and pump. Professional built driveshaft with solid aluminum hanger bearing with rear slip & stub section. Rear brakes completely rebuilt, all new parts and brake lines front to backand hoses. Front disc brake conversion. Seven inch power booster, new master cylinder. Engine is a LS 6 liter iron block, aluminum heads, LS6 intake withHolley fuel railswith about 80,000 miles with a 4L80E transmission shifted by a B&M Quicksilver floor mounted shifter. Muscle car oil pan kit conversion.Rearendwas replaced with Eaton Limited Slip and 370 gears, new seals professionally built. VintageAirLS front runner system with chrome alternator, a/c compressor and power steering pump. Lokar Hi-tech throttle cable, LS throttle bracket double stud. Lokar XL Chrome Steel gas pedal with rubber. Lokar Hi-tech transmission dipstick. New spark plugs and wires. LS1/LS6 Blockhugger steel ceramic coated headers. Fuel Injection Connections, Golden, CO complete new LS wiring harness and reprogrammed computer. C,G&J Inc. Gadsen, AL built aluminum radiator with LS setup. 16 inch 225W Rev. Challenger fan with shroud and GM billet radiator cap. Racetronix in tank fuel pump and sending unit, GM Corvette fuel filter and regulator. Flexible and solid fuel lines with AN fittings. Sheet metalthat has been replaced is front floor brace, under seat rear brace, 18" floor brace,outer and inner factory rockers, box brace at rear wheel, full floor toe board to rear seat floor, full quarters. New 1962Chevy hood after market fits very good. All body work done except for final blocking and is then ready for paint.Was jammed blue and silver as was going to paint top blue and sides silver. 2 original front and rear bumpers. NOS valence panel between front fenders and bumpers. 2 or 3 cowl panels. Interior includes Monte Carlo bucket seats 2 sets, aluminum dash gauge inset with Classic Instruments gauge package, tilt steering wheel with collapsible shaft to steering box. Mirror bracket redone, chromed and polished, 1962 mirror new reproduction. Interior/exterior screw kit.Vintage air conversion for 1962 Impala. American Autowire complete wiring kit, complete from front to back, engine, interior and exterior. Exterior parts new or redone include Impala script and deer trim for rear quarters, hood lip Chevrolet trim 1 redone and 1 new. Front and rear bumper inserts new. Upper side exterior trim 6 pieces completely redone, all dings taken out, re-anodized and polished. Front hood and rear trunk emblems new, wiper arms and blades new, new mirrors for both sides, 2 rear deck antennas nos, front fender side flag emblems rechromed and painted, tail light bezels redone, reanodized, nos tail light and backup lenses with ornaments. As you can see this has been an ongoing project and I have accumulated a lot of parts. Engine, transmission and drive shaft are hooked up. Car starts and runs fine, drove around the block several times but cannot drive on street yet. I am sure I have left stuff out. Deposit of $500.00 per cashiers check is due within 5 days of sale and remainder of sale price in cash at time of pickup within 14 days of closing sale. Cannot pick up till cashiers check clears the bank. Must be picked up by buyer locally,will not ship through shipping company as there is too much to pick up.