1937 Chevrolet Other Pickups
1937 Chevy half ton pickup truck, cab and frame from 1937. Engine is 235 CID inline 6 cylinder from 1958 pickup truck (runs - purchased as being rebuilt, bored .30 over and less than 600 miles), short shaft water pump and pusher air fan. Original fan blade also included.Front and rear axles from 1954 pickup, disk brake set up on front axle, transmission is 5 speedfrom 1989 S10. Radiator has been rebuilt, has GM high pressure oil gauge, comes with new ampere, oil, water temp and gauges, electronic ignition, two 12 volt alternators and adapter.Cab comes with original trim (believe it is complete, window and door trim, door panels and window handles), pot metal rear window frame is intact, screw tracks in good shape.Fiberglass floor board and plywood toe board. 1935 4 panel hood and complete grill, emblems and crank hole cover. Small amount of rust on one door, rocker panel and cowl of cab. Three holes were punched out for cab lights, need repair.Truck comes with a windshield frame, not sure if correct, headlights, tail lights and mounts (after market), turn signal indicator and wiring kit.Bed - front panel from 1937, tailgate after market, bed sides from 1954 Chevrolet pickupWheels - five 17 inch, 6 lug wheels that were sand blasted, and painted red. Coke rubber, and dog dish hubcaps
Brakes converted to dual master cylinder and brake lines replaced, but leak.Gas tank is spun aluminum with fuel level indicator.Original VIN plate comes with truckThere are other parts as well, one dash in truck as well as another dashMore pictures will be postedTruck is in Canton, GA 30114 and available for review.
Must pick up in Canton, GANo returns, sold as is, where isPlease ask questions