1970 Chevrolet C-10 Custom 4X4

Price: - Item location: Santee, California, United States
Description:

1970 Chevrolet C-10

1970 Chevrolet C-10 Custom

This truck is FULLY Operational, starts up instantly, run and drives, is registered in California until November 2017

It is however an unfinished project at approximately 90% completion in my opinion and for my use. you may want to take it to the next level for your use. all parts I have will be included, including the original Bed/tailgate/rear bumper assembly.

I was never planning on selling this truck, it was to be our ranch truck and stay on the ranch forever, however due to a recent financial set back looks like she has to go, and I'll just have to start over again someday.
I am not in the vehicle sales business and not sure what to mention here, I will try to make this as comprehensive a list as possible of what was in the planning to complete. feel free to ask questions or request more pictures
  • Semi Frame off to check / clean / treat any rust spots, was not much to start with

  • Minor body rust here and there in the usual spots, rockers rusted through and were going to be repaired next. rust spots on bottom of both doors and center of driver door

  • 14 bolt (1 ton) rear end , 373 gears

  • Transmission TR350 rebuilt all the good stuff, Hughes torque converter

  • Crate 383 Stroker ($7500), Weiand intake, HEI distributor, (see pictures) less than 1250 miles on engine

  • Ceramic Headers, all new 2 1/2 dual pipes with Dynomax turbo mufflers and bullet resonators (sounds great, deep low rumble, I added the bullet glasspacks recently in line to tone it down just a little more as we need to occasionally pull a loaded horse trailer and didn't want to scare the horses)
  • New Pro comp 35/12.50/15 Xtreme M/T tires ($2200) rally wheels, new wider in rear
  • Dana 44 front axle, spicer locking hubs, 373 gears, needs ball joints replaced soon (new spicer ball joints, and hub seals included)

  • New Front disk brakes and rotors (was planning on redoing all plumbing for brakes and transmission, all is working fine just not routed as I would like)

  • new power steering pump and steering gear just installed (needs fine tuning).

  • NP205 Transfer case rebuilt and with dual stick option, front drive shaft included / not installed yet (was planning on purchasing dual stick after completion of interior)

  • New FullRiver FT825-34 Battery ($220).

  • New Dash Cluster.

  • New rear window and seal (includes all rubber for all windows and door seals (front window cracked and was to be replaced soon). replaced all rubber / widow track and inside hardware on drivers side, still need to do passenger side

  • period correct hi back Bench seat with center console (was planning on reupholster), new lap belts
  • 8 track radio installed (not hooked up) 24 tape glove box insert
  • CM Flat bed ($3500) (with LED lighting, goose neck hitch, New underbody box ($300) with tool drawers
  • Original Bed / tail gate/ recever bumper included, bed in very good condition with very minor rust
  • New Gabriel hijacker air shocks in rear, new shocks in front, billstein dual steering stabilizers included / not installed
  • will add more as I think of it, feel free to ask questions

  • would prefer local pick-up, but willing to ship with your help, or willing to do anything I can to assist with your shipping request.


    On Jun-06-17 at 19:56:11 PDT, seller added the following information:


    1970 C10
    click to enlarge

    On Jun-06-17 at 20:00:53 PDT, seller added the following information:


    1970 C10
    click to enlarge