1973 Plymouth 'Cuda 340 Sassy grass green, mopar, barracuda,
1973 Plymouth Barracuda 'Cuda
Real 1973 Plymouth 'Cuda 340 (#'s matching Canadian Car)
VIN: BS23H3B337086
This hard decision as been in the making for the past 3 years and we finally decided to proceed with selling our beloved 'Cuda which we've owned for the past 20 years because we are simply not using it enough due to our two young boys keeping us very busy!
This beautiful 73' 'Cuda 340 has undergone a complete rotisserie Restoration. We are the 5th owners of this Canadian car, it was first purchased new in Ottawa Ontario and stayed in the area its entire life. We acquired the car in 1999 with only 56000 original miles(pictures of the 'Cuda the way it was when we purchased it in orange are attached). We began restoration in 2000 restored the car over the following 4 years. Under the hood sits the original # matching block (bored.030") and original heads. In 2004 after driving it for that summer, we removed the A-833 4 - speed manual transmission setup along with the 4.56:1 rear gears and my husband built the original 727 and also installed new yukon 3.91:1 rear gears, this made the car a lot more enjoyable and streetable. The exterior has been finished in Sassy Grass Green code FJ6 and features 1971 340 billboard stripes and the 1970 A.A.R. Black hood, fender tops and door tops paint scheme. The underside is as nice and shiny as the top! The Interior was restored and features new carpeting, the headliner, door panels, dash pad remains original and in like new condition. As for the seats they were in nice condition but the vinyl was "dry rotted/brittle" so the upholstery was removed and Un-stiched. 3 longhorn hides of fine leather were used and the seats were redone to match the original pattern but in fine leather along with the late 60's Plymouth devil tail heart Logo in the seat headrest section. A roll cage was installed during the restoration and is covered in the same fine leather along with late 60's Barracuda fish logo's and the white Plymouth name. Due note that the roll cage can easily be removed if a new owner would wish to keep the interior stock. All work and restoration work was completed by us in our shop, only thing outsourced was the leather upholstery work and the engine Dyno tests/Pulls. This is one gorgeous 'Cuda built for show and go. Only the best of everything was used and high attention to detail to all work performed( My husband is ....real picky) Nothing on this car was altered that cannot be removed to return the car to 100% original if desired. This car comes with a ton of pictures of all work, awards, news paper articles, a ton of documentation including, original Broadcast sheet in superb condition, previous owners list, license bureau history information package, receipts of all parts that were purchased along with sketched of all parts which were custom made in the shop like the blower belt drive guard, etc. There is simply too much stuff to list here. the car needs nothing, simply turn key and go!
Note that our Black 1868 Charger seen in the photos is not for sale!.!..
1000$ deposit required once auction closes and is non refundable, rest of the balance to be received no more than 10 days after auction ends and prior to the vehicles pickup!
Lets not waste each others times, please serious bidders only. Once car is paid in full, We are willing to have the car remain in our shop for a delayed pickup or to assist in shipping arrangements.
There is simply too much stuff to list, be here is a small list of some of the stuff found on this 'Cuda:
Mechanics:
Plymouth 340ci # matching block
-Gary Dyer's 6-71 supercharger
- 2x Holley 4150 double pumpers with mechanical secondaries
Harland sharp roller rocker setup
Mopar mono gear drive timing setup
ATI vibration damper
Oil filter relocation system with dual filter cartriges
Trans: Torqueflite 727 filled with the best of everything including a deep cast aluminum pan, ATi torque converter, TCI outlaw pistol grip shifter, Bear's Chrome Moly dynamically balanced drive shaft with 1350 joints and billet slip yoke and billet rear diff yoke
8 3/4 Rear End
- Gear Ratio: 3.91:1
-Yukon gears
-Yukon axles
-Green bearings
-Sure Grip
Brakes:
Front - Power Disc
Rear - Power Drum
Exhaust:
Hooker super competition headers with a full 3" TTI exhaust system and Cuda stainless TTI tips
Wheels and Tires
Front Wheels: 15"x7"
Rear Wheels: 15"x8"
Front Tires: BFGoodrich Radial T/A 245/60R15
Rear Tires: BFGoodrich Radial T/A 275/60R15
Underneath:
- Tank is New
- Exhaust is New TTI
- Exhaust Hangers TTI
- Frame connectors
- Brake Line, stainless steel
- Fuel Line Braided stainless and aeroquip fittings
Electrical: 120Amp Alt, all new wiring with modern fuse panel, derale trans cooler and oil coolers with fans, MSD ingnition 6AL box with rev limiter and a MSD boost timing retard module.
Interior:
- Door Panels look Great
- Steering Wheel in Great Shape
- Upholstery looks Amazing
- Front and Rear Seat Belts
- very nice original headliner
- Original dash pad still in immaculate condition
- all white face autometer Phantom gauges, accurate interior fuel pressure gauge with under hood fuel isolator to keep actual fuel away from passenger compartment.
-new carpet and floor mats
The vehicle is located approx 2 hours north of the New York state border and Canada.
- Make: Plymouth
- Model: Barracuda
- SubModel: 'Cuda
- Type: Coupe
- Trim: 'Cuda
- Year: 1973
- Mileage: 56000
- VIN: BS23H3B337086
- Color: Green
- Engine size: Numbers matching 340 (6-71 supercharger)
- Number of cylinders: 8
- Fuel: Gasoline
- Transmission: Automatic( Full manual reverse VB)
- Drive type: RWD
- Interior color: Black
- Options: CD Player, Leather Seats
- Vehicle Title: Clear Want to buy? Contact seller!
